Skip to main content
ASTRAVYR
ASTRAVYR / CONTROL, WEATHER & REMOTE OPERATIONS

Observatory Automation & Telescope Control Equipment

Specify the automation behind an observatory: power, focusing, instrument interfaces, weather sensing and safe enclosure control.

Specific manufacturers and configurations are not approved until technical, commercial and destination checks are complete.
01 / EQUIPMENT COLLECTION

What belongs in this equipment family.

Supervised and remote civilian observing with documented controls and defined local integration. The listed instruments are potential procurement scopes, not stock records, authorised dealerships or certified complete systems.

01 / SYSTEM GROUP

Observatory weather monitoring

Cloud, precipitation, wind and environmental sensor candidates for an observatory's decision and alerting system.

Relevant buyers: Remote observatories and site operators

Verify before quotation
  • Sensor outputs, calibration and local conditions
  • Failure states and sensor-degradation response
  • Integration with enclosure/weather-control logic
02 / SYSTEM GROUP

Dome and roll-off roof controls

Controllers, motor interfaces, shutter/roof interlocks and manual/emergency control concepts.

Relevant buyers: Enclosure suppliers and local system integrators

Verify before quotation
  • Roof or shutter movement envelope and mechanical limits
  • Power/network-loss behaviour and safe manual recovery
  • Site-specific engineering and integration responsibility
03 / SYSTEM GROUP

Power, data and device management

Power distribution, USB/data interfaces, cable management and power-continuity candidates.

Relevant buyers: Imaging and remote-observing projects

Verify before quotation
  • Electrical input/output capacity and protection
  • Device, firmware and software compatibility
  • Backup power and protected shutdown procedure
04 / SYSTEM GROUP

Focusing, guiding and mount interfaces

Motor focusers, rotator controls and telescope-guiding interface candidates.

Relevant buyers: Research and astrophotography systems

Verify before quotation
  • Optical tube and mechanical coupling dimensions
  • Mount/driver protocols and software support
  • Travel limits, payload and equipment compatibility
05 / SYSTEM GROUP

Remote monitoring and supervision

System status, alarms, event logging and remote-operation interface requirements.

Relevant buyers: Distributed astronomy and university programmes

Verify before quotation
  • Connectivity and cybersecurity requirements
  • Responsible operator and alert escalation
  • System recovery, inspection and preventive maintenance
02 / BUYER SPECIFICATION CHECKLIST

The key details to send with your enquiry.

These details allow a specialist supplier to determine whether a supported model and configuration exist for the intended country, scientific objective and installation environment.

Open complete RFP checklist
  1. 01

    Observatory geometry, enclosure type and mechanism drawings

  2. 02

    Telescope/mount models and existing control interfaces

  3. 03

    Power supply, connectivity and environmental conditions

  4. 04

    Supervised versus unattended use and risk assessment

  5. 05

    Safety interlocks, emergency recovery and commissioning owner

03 / SUPPLY-ONLY TECHNICAL ENQUIRY

Prepare an equipment enquiry.

Selected equipment groups are included automatically. Use your project location, scientific application and existing instruments to make the request useful for technical qualification.

0 of 5 equipment groups selected

Continue to Apollo enquiry form

This opens Apollo's existing enquiry form with your brief; no message is submitted until you complete that form. For extensive specifications, provide an attachment or full document separately.

04 / BUYER QUESTIONS

Questions to resolve early.

Can controllers automatically close a dome in bad weather?

Some systems may support weather response, but closure depends on the exact controller, actuator, sensors, interlocks and loss-of-power behaviour. Automatic safe closure must be verified at the complete site-system level.

Can automation work with an existing telescope?

Possibly. Specify exact telescope, mount, enclosure, software drivers, firmware and control interfaces for an engineering compatibility assessment.

Evidence first. Commercial commitment second.

The specialist equipment families below are project-scoping categories, not manufacturer-authorised listings or guaranteed stock. Model and manufacturer rights, technical performance, compliance, warranty and destination must be verified individually.

Project